Cougar KR SVR – Build Tips

- Schumacher Cougar SVR - Build Tips -

the diff circlip has a flat side and a radius edge side-be careful, install it per book--study the picture
diff pulley also has two different side, be careful, study the pic
ca glue (coat one very small drop) the anti squat sqaure-wait til it dries-so the pivot sphere fits snugged and doesnt get glued to the anti squat sqaure cut out-install per manual's directions..this will help prevent play here
use carbide diff balls if the stock ceramics slips, or tighten down the ceramics
coat ca on the shock towers edge
replace the rear tranny case with the newly updated/stronger tranny case
do not overtighten the wheel nut but, it may cause the axle to break, but make sure its tight,
lock tight the anti squat screws (not in manual)
diff thrust bearing has a small washer and big washer--dont get them mixed up
green slime shock orings
make sure the long diff screw is on the left side and short screw on the right side----do it per exploded pic
seen a few with this error, do not over tighten the front bottom shock screw, it will actually bind the front arm hinge pin.