X6 – Chassis Details

-
X-Factory X-6 - Details
of X-6 Chassis Lay-out
-

Top view shows unique transmission giving
mid-motor layout. Also 4+2 battery configuration for best weight
distribution front-to-back and side-to-side. Car's mass is centered ahead
of the rear axle for best cornering, jumping, and stability over bumps.
Also shown: unique wing mounts to stop wing flew generating more downforce
from the same wing area.

Close-up of transmission and motor plate.
Note vertical bolts holding transmission in car. Shims can easily be
added/subtracted to change height of outdrives for different track
conditions. This affects forward/side bite. Front of motor plate bolted to
chassis for extra rigidity. Car has virtually zero flex.

Rear suspension mounting system. Two
different toe-in bars supplied with each Kit, giving 3 degrees toe-in or
four per side. Note slots under the two washers -- Vertical screws from
under the chassis go into the toe-in bar. Add/subtract shims quickly to
set anti-squat.

Bottom view of "graphite" chassis
showing lowered batteries and molded "graphite" rear control
arms. Four steel threaded inserts are used to hold the transmission in the
car adding strength.

Source: XFactoryRC