Starting Setup

This setup had a neutral feel with a
slight push. Things i want to try on setup are rear sway bar,
changing front inboard camber washers, set front belt back to
standard tension, try a one way pulley, put some holes in body for
better cooling on the electrics, trim wing to standard line &
maybe just some other fine tuning. I think that's all for now.

Camber

• negative 1 degree all round

Front toe in - straight

Ride height (measured without undertray for accuracy)

Front - 26mm

Rear - 25mm

Rear suspension -

Wheelbase

• medium

Roll bar - none

Toe in - 3.25 degrees (3mm in rear, 0.5mm in front)

Lower shock position - in

Upper shock position - in

Hub - middle

Brace - 49mm

Inboard camber washers - 2mm

Rear anti squat - 1.3 degrees (rear 2mm, front 1mm)

Front
track washers - 1mm front & rear

Roll bar - none

Inboard camber washers - none

Outboard camber washers - none

Front rake - 10 degrees

Brace - 44 mm

Lower shock position - middle

Upper shock position - middle

Front -

35wt

2 holes

Losi orange springs

Diaphram spec - standard

Shock length - 82mm

35wt

3 holes

Losi pink springs

Diaphram spec - standard

Shock length - 94.5mm

I also put 3 Associated 'o' rings on the rear shock shafts to
prevent the outdrives from binding with the universals

Rear diff - low

Front diff - low

Front layshaft pulley - fixed

Front drive - diff

Front overdrive - no

Spur - 83

Pinion - 24

Internal ratio - 2.6

ESC - LRP Sphere

Servo - Futaba S9451

Reciever - Spectrum SR3100 DSM2

Battery - Reedy 20C LIPO 5000mah

Motor - Novak 7.5

Front tyres - Losi silver tapers,
standard foam not trimmed

Rear tyres - Losi red BK bars, proline 2 stage foam

Losi spring lengths - front 2.0,
rear - 2.5

Diff setting - front & rear - 45 degree back off from close

Slipper was set to have minimal slip

When mounting the battery, after gluing the tabs that slot into
the chassis i then trimmed some thin lexan & glued that on the
side of the tabs to stop the batter from having any play. I made
it so it was a snug fit but not tight as that could after time
tweak a chassis.

Both side vents were cut out on the body.