Batley SuperCup

Batley Super Cup: Slippy floor and
carpet, plus some rippled mats.

Front

Blue Spring
Additional 57 hole in piston
Oil 35wt
ball joint done up on shock just
showing thread
push rod turnbuckle - 34mm -
mounted on top of rocker
top wishbone about in the middle
(equal spacing front/rear)
ride height - slightly lower
than the back
max droop
Roll bar in long link (rear hole
in wishbone)
camber 1 deg
Slight toe in
Standard wing with 2mm spacer
under rear mounting hole

Rear

White/Silver spring with
compensator spring
lower mounting hole on wishbone
Additional 57 hole in piston
(standard one is about 57 also)
30wt oil
Lower hole on the hub (high
position)
Roll bar in short link (rear
hole in wishbone)
wing forward half gurney
toe-in 3 degs
1 deg camber
ride height - wishbone level
max droop

Extras

Motor LRP X12 6.5 (20/72), LRP
Sphere Comp ESC
One-way shaft - three o-rings on
brake bias
Bumper cut down to improve
ground clearance on landing jumps
Cone washers on top of front
hubs removed and replaced with two 1mm washers underneath the
wishbone and 1 on top.
Rear anti-roll bar lowered
Schumacher Mini-pins - yellow
compound with blue foams/inserts
Cut the inner two rings off the
surface of the rims
Stick Lipo conversion (5000mah
lipo set far forward as possible)