NERCR

NERCR -
Slippy floor and carpet, one large jump plus some rippled mats
Front

Blue Spring

Additional 57 hole in piston

Oil 35wt

ball joint done up on shock just showing thread

push rod turnbuckle - 34mm - mounted on top of rocker

top wishbone fully back except for two small washers

ride height - slightly lower than the back

max droop

Roll bar in long link (rear hole in wishbone)

camber 1 deg

Slight toe out

Standard wing

Blue spring
with compensator spring

middle hole on wishbone (thats with the longer shaft, may need lower
hole)

Additional 57 hole in piston (standard one is about 57 also)

30wt oil depending on temp

Lower hole on the hub [high position]

Roll bar in short link (rear hole in wishbone)

wing forward half gurney

toe-in 3 degs

1 deg camber

ride height - wishbone level

max droop

Motor LRP
x11 bonded 6.5

One-way shaft - three o-rings on brake bias

Bumper cut down to improve ground clearance on landing jumps - see
picture

Cone washers on top of front hubs removed and replaced with two 1mm
washers underneath the wishbone and 1 on top.

Rear anti-roll bar lowered

Schumacher Mini-pins - yellow compound with blue foams/inserts

Cut the inner two rings off the surface of the rims (see picture)