At 360 RC Speedway's "The
Gaunlet" race yesterday I ran 1/12th Stock and 19T. I really
feel that tires are the key to getting this car set-up. I was a
Purple Front/Grey Rear guy but I think the car responds better to
equal front/rear tire hardness combos or softer front than rear. I
tried two different set-up directions yesterday (I ran the same
Parma Speed 8 body on both cars):

1 - Had tons of steering that I

needed to put a 50% delay into my radio. Ran this setup in Stock
but proved it works well in 13.5T during practice.

Front:

Jaco Magenta

Paragon on inner 1/2

.018 springs

4deg caster

-1deg camber

10K silicone in lower pivot ball

Angled servo

Jaco Magenta

Paragon full

Thin hockey sticks w/ tweak screws touching

40WT

Wind Tunnel 15# "V" Hive VCS Spring

Long ball stud

Wind Tunnel #3 Green Shur Lube

Front:

Jaco Lilac

Paragon on inner 1/2

.018 springs

6deg caster

-1deg camber

10K silicone in lower pivot ball

flat servo

medium ball studs

Jaco Grey

Paragon full

Thin hockey sticks w/ tweak screws touching

40WT

Wind Tunnel 15# "V" Hive VCS Spring

Long ball stud

Wind Tunnel #4 Red Shur Lube