Seattle Raceway

FRONT

gold springs

3mm spacer above upper arm, 1mm spacer below knuckle.

Steering links mounter on underside of knuckle in rear postion,
.5deg toe out

b3s with tamiya hard insert, 1/2 to 3/4 (depending on grip level)
pargaon 1min soak.

80wt w/ 3 hole white piston.

white spring with red dot (the ones that comes with the hop-up
shock)

2mm spacer under front shock mount

flex pate t-bat w/ stock o-ring setup,
~ 2 turns tighter than factory setting.

50/50 mix of tamiya medium & soft friction grease w/ plastic
friction discs, springs adjusted for even light tension

Shock adjusted to make pod level with chassis.

~8oz total battery weight, 3200 lipo w/ 1 oz of lead centered
under battery

B3s w/ tamiya kit type foam strips
(the softest charcoal one) narrowed to 24mm.

paragon over full tire, 3min soak.

Diff set just tight enough to not slip w/ 2 spring washers

23/104 w/ the kit included silver
can