Bending Corners

I'm about to tear my car down and try
a completely different setup, so before I do I'll post the setup
from Bending Cornerz that a few people have been asking for.

My setups don't work for everyone,
generally they lack rear end grip and have a ton of initial
steering. It took me years to get used to driving a car like this
but if you can drive it smooth enough I feel like it can keep up
with anyone.

The track is a small tight outdoor
asphalt track, medium grip.

FRONT

Upper Arm Position: 3

Upper Arm Spacer: 2mm

Damper Position: 2

Lower Arm Position: 1

Sus. Mount Spacer: F=.5mm R=1mm

Camber: 1.5*

Ride Height: 5.4mm

Rebound: 100%

Front Drive: Spool

Stabilizer: 1.5mm

Wheel Hex: 4mm

Wheel Spacer: .5mm

Piston: 3 Hole

Oil: 550

Spring: HPI Pink

Front Pulley: 36 Tooth

Droop: 25mm from bottom of the chassis to the top of the axle
measured with the car on a flat board.

Evo 5 front arms

Upper Arm Position: 1

Upper Arm Spacer: 2mm

Upper Arm Spacer On Hub: 2mm

Damper Position: 5

Lower Arm Position: 2

Sus. Mount Spacer: F=0 R=0

Camber: 1*

Ride Height: 5.6mm

Rebound: 100%

Stabilizer: 1.4mm

Wheel Hex: 4mm

Wheel Spacer: .5mm

Piston: 3 Hole

Oil: 550

Spring: HPI Blue

Droop: 25mm from bottom of the chassis to the top of the axle
measured with the car on a flat board.

Evo 5 rear arms

Front Toe Angle: 0*

Front Sus. Mount F=C R=C

Rear Sus. Mount F=XA R=D

Upright Spacer: .5mm

Steering Spacer: 4mm

Rear Hub Spacer: .5mm

Center Pulley: Direct

Front Sus. Arm Spacer: 2.5mm

Rear Sus. Arm Spacer: 3mm

Lower Deck: 2.25mm

Body: Protoform Mazda 6 LW, 6mm Forward

Tire: Sorex 36R

Motor: Orion Vortex 4.5, geared 26/104

Battery: Orion 3800 Lipo

Wheels: Tamiya