Iwate prefecture

The latest report tried
trying the change of the quality with the difference of the front
spring.

Usually you use the
spring which this time is tried,

For
CRC Gen-X 0.45mm (spring diameter 4.6mm, free length 5mm) other
things

Wolfe Motor Sports 0.018 (approximately 0.45mm) (spring diameter
5.0mm, free length 5.7mm): Being out of print

The software 0.45mm for [kawada] M300 (spring diameter 4.5mm, free
length 5.7mm)

It tried trying.

Adjusting the length of
the king pin, also each spring adjusted preload 0.

Other than of the front spring has become like below.

Use model [kapetsutonaihu]
generation X

**Front

**Tire: Potential miracle doughnut software 43mm CRC
HR38 foil

Spring: -------------

Camber: - 1 times

Variable caster: - 10 degrees

CRC aluminum make front end breath

Caster: Center (on front and back of caster block shim 2 (0.5mm))

Toe: 0mm

[rorusentakitsuto]
use (CRC3230) + steering wheel block processing

F [roapipotsutoboru] processed + king
pin the shim (it is thin) 6 (CRC4730)

Spacer under [roaamu]: 4.5mm

Freeboard: Approximately 3.5mm (chassis front end)

Grip medicine: [paragon] black can 20 minute extensively

In addition:　　

Loading AMB [dairekutoponda]

**Center

**[sentashiyotsuku]: [kawada] make 6.5mm [shiyotsukuoiruasoshi]
#50

Spring: CRC
lead-lead

Battery helicopter loading site: Anterior

hard ([aokiyatsupu]) use

Droop: - 0.5mm (in lower brace rear end measurement)

Freeboard: Approximately 3.5mm (battery side)

**Rear

**Tire: [kawada] L rubber SH 43.5mm CRC
HR38 foil

Gear: 20/88

As for [dehuboru] ceramics
of kimihiko-yano.net sale

Grip medicine: [paragon] black can 20 minute extensively

[haitoadaputa]: IRS 2.0mm down

Freeboard: Approximately 3.5mm (lower brace rear end)

Body: There is a [purotohuomusupido] 8 spoiler,

Motor: Team
Brood checkpoint base 8x2

Battery: IB4200

Something related to RC device

Transmitter: Helicopter male

Servo: NES-3125

Receiver: KO 302F

Power source for receiver: VXR make lipo
120mA+ regulator